Skip to content
HelpfulCoin

Is Balancer Safe After Its 2025 Attack? Review

Balancer is an Ethereum-based decentralised exchange and liquidity protocol. Its 2025 cross-chain attack makes careful checks of the specific pools and contracts especially important.

Researched and written by the HelpfulCoin teamChecked 10 questions answered

The short answer

Balancer may suit experienced DeFi users who understand pool and smart-contract risks, but it is not a low-risk place to start. It offers non-custodial token swaps and liquidity pools on Ethereum, yet a reported 2025 attack caused losses exceeding $128 million. Before connecting a wallet, verify the exact contracts and pools you plan to use, and do not assume the incident has no bearing on them.

Our verdict:Avoid3.8/10

HelpfulCoin report card

Avoid

3.8/ 10 overall

Serious problems, or it no longer works.

SafetyHow funds are held, audits, licence, incidents.
F (2.5 out of 10)
CostsFees, spreads, gas, house edge and bonus terms. Higher is cheaper.
C (5.5 out of 10)
Ease of useHow easy it is for a newcomer to start, use and withdraw.
D (5.0 out of 10)
ReputationHow established and openly run it is.
D (5.0 out of 10)

Grades: A 8.5+, B 7+, C 5.5+, D 4+, F below 4. A dash means the project doesn't publish enough to grade it.

Balancer at a glance

What it is
Decentralised exchange and liquidity protocol
Chain
Ethereum
Token
BAL (ERC-20)
Custody
Non-custodial wallet interactions
History
Balancer V2 operating since 2020
Incident
Reported cross-chain attack in 2025
Last checked

Green flags and red flags

Reassuring

  • Balancer uses a non-custodial wallet model rather than holding user funds in a conventional exchange account.
  • Its BAL token is an Ethereum ERC-20 token associated with protocol governance.

Be careful about

  • Balancer suffered a reported cross-chain attack in 2025 with losses exceeding $128 million.
  • The status of remaining affected funds and current audit coverage is not clear.
  • Liquidity providers can lose value through token-price movements as well as contract failures.

What is Balancer and what can you do with it?

Balancer is a decentralised exchange (DEX) on Ethereum that uses smart-contract pools to trade tokens. Unlike a conventional exchange, it does not match orders through a company-run order book. Its automated market maker (AMM) pools hold token reserves, and trades change the balance of those reserves. Balancer also lets users supply tokens to pools as liquidity providers and receive a share of the pool’s trading fees. Some pools can hold several tokens or use different token weights, so Balancer can also function as an automated portfolio. You interact through a crypto wallet rather than a regular brokerage account. The BAL token is associated with the protocol and is used for governance.

Is Balancer safe to use after its 2025 attack?

Balancer is non-custodial: you connect a wallet and approve transactions, rather than handing your tokens to a central exchange to hold. That limits one kind of risk, but it does not remove the risk of smart-contract bugs, malicious approvals, pool losses or wallet mistakes. Balancer suffered a reported cross-chain attack in 2025, with losses exceeding $128 million; about $28 million was reportedly recovered. That is a major reason to be cautious. Check the exact pool and contracts you intend to use, and do not assume every deployment was affected or repaired alike. Balancer’s current audit coverage and the status of any remaining affected funds are not clear. A non-custodial design is not a safety guarantee.

Is Balancer legit, and who runs it?

Balancer’s legitimacy is supported by its long-running presence as a DeFi protocol: Balancer V2 is described as operating from 2020, and its BAL token is an Ethereum ERC-20 token. But a long history does not erase the serious 2025 exploit. The people or legal entity currently responsible for operating the protocol, its licensing status and its current audit coverage are not clear. Balancer is a protocol, not a conventional exchange account, so there may not be one company providing the same recourse an exchange customer might expect. Treat the history as evidence that it is a real, established protocol—not proof that every pool is safe or that users can recover funds after a contract failure.

What fees does Balancer charge for swaps and liquidity?

Balancer’s costs depend on the pool and transaction. A swap can incur a pool trading fee, and every Ethereum transaction also requires gas, the network fee paid to process it. Pool fees are not one fixed protocol-wide rate; check the specific pool’s fee before confirming a trade. Providing or removing liquidity also requires on-chain transactions, so gas applies there too. If a trade routes through more than one pool, the applicable pool fees and price impact can affect the total cost. Balancer does not publish one simple all-in fee that covers every user and pool. Compare the amount you expect to receive with the amount shown for the transaction, and remember that gas can change with network activity.

How do you use Balancer to swap tokens or provide liquidity?

Balancer’s pools use smart contracts to exchange tokens and manage liquidity. For a swap, connect a compatible wallet, choose the tokens and amount, review the route, pool fee, price impact and gas estimate, then approve and submit the transaction. A wallet connection by itself does not move funds; token approvals and transactions do. For liquidity, select a pool and deposit the required token amounts. Pool rules differ, including the tokens and proportions they accept. In return, liquidity providers generally receive Balancer Pool Tokens (BPT), which represent their share of the pool. This is not a risk-free savings account: token prices can move against the pool, and smart-contract problems can cause losses. Check the contract and pool carefully before signing.

How do Balancer deposits and withdrawals work, and are there limits?

You deposit by connecting a self-custody wallet and approving the token and pool transactions; there is no conventional bank deposit into a Balancer account. To withdraw liquidity, use the pool interface to remove your position and receive the pool’s underlying tokens, subject to the pool’s rules and available balances. A swap or withdrawal is an on-chain transaction, so you need the relevant network’s native token to pay gas. Balancer does not publish a single account-wide deposit or withdrawal limit because it is a smart-contract protocol, but pool capacity and contract conditions can constrain what you can trade or remove. No central account-based KYC process is described for these wallet interactions; using a separate service to buy crypto may have its own checks.

What is the BAL token, and does it earn Balancer fees?

BAL is Balancer’s Ethereum ERC-20 token and is associated with protocol governance. Holding BAL is different from holding a claim on funds in a Balancer pool: the token does not guarantee a return or give you an automatic share of trading fees. Pool liquidity providers may earn pool fees, but their results depend on pool conditions and token prices. Before supplying liquidity, check what assets the pool holds, how its balances are weighted, its current fee and how you will remove your position. A pool can lose value relative to simply holding its tokens because prices move and the pool rebalances. BAL’s market price can also change independently of the performance of any particular pool.

Before you deposit: a quick checklist

  • Check whether the exact Balancer pool and contracts you plan to use were affected by the 2025 attack and what remediation applies.
  • Verify the network and token contract addresses before approving a transaction.
  • Review the pool fee, price impact, token mix and gas cost before swapping or adding liquidity.
  • Use a wallet with only the funds you intend to risk, and review token approvals.

4 steps

How to get started with Balancer

  1. 1

    Check that using Balancer and the relevant crypto services is permitted where you live.

  2. 2

    Confirm the exact pool and contract addresses, and check their status in light of the 2025 attack.

  3. 3

    Connect a wallet that holds only the funds you intend to use, and inspect token approvals.

  4. 4

    Review the pool fee, price impact and gas estimate before signing; start with a small transaction if you proceed.

Plain English

Jargon explained

AMM
A smart-contract pool that holds tokens and enables trades without a traditional order book.
Liquidity
Tokens deposited into a pool so it can facilitate trades.
BPT
The token representing a user’s share of a Balancer pool.
Gas
The network fee paid to process a transaction on Ethereum.

Quick answers about Balancer

What does BPT mean on Balancer?

BPT means Balancer Pool Token. It represents a liquidity provider’s share of a particular pool; it is not the same as BAL.

Can you swap BAL on Balancer?

Yes, if BAL is available in a pool or trading route on the interface you use. Check the token address and quote carefully, since a token’s name alone does not verify that it is genuine.

Can you earn guaranteed income by providing Balancer liquidity?

No. Supplying tokens to a pool exposes you to token-price changes, pool-specific risks and smart-contract risk, and returns are not guaranteed.

Compare

Balancer alternatives

All alternatives
Uniswap V3 logoScore 7.2 out of 10

Uniswap V3 is a wallet-based decentralized exchange; it is worth a look, but swaps and liquidity positions carry on-chain risks.

TVL $1.30B−11.9%Ethereum · Base · Arbitrum +38
Uniswap V4 logoScore 7.0 out of 10

Uniswap V4 is a non-custodial token-swapping protocol with customizable pools; worth a look if you understand its contract and hook risks.

TVL $1.02B−6.7%Ethereum · Robinhood Chain · Base +19
Uniswap V2 logoScore 7.1 out of 10

Uniswap V2 is a non-custodial token-swap protocol with a long track record, but trades and liquidity positions carry smart-contract and market risks.

TVL $720M−13.4%Ethereum · Base · Polygon +14
PancakeSwap AMM V3 logoScore 6.6 out of 10

PancakeSwap AMM V3 is a multichain DEX for swaps and concentrated liquidity; it merits a look, but carries contract and liquidity risks.

TVL $641M−7.5%BNB Chain · Ethereum · Base +8
Fluid DEX logoScore 5.8 out of 10

Fluid DEX is an on-chain swap and liquidity protocol on five networks; it merits a look with careful checks on contracts, fees and risk.

TVL $198M−6.2%Ethereum · Arbitrum · Base +2
SushiSwap logoScore 6.5 out of 10

SushiSwap is a multichain decentralized exchange for wallet-based token swaps, worth a look if you understand the risks.

TVL $30.5M−10.8%Ethereum · Polygon · Arbitrum +32

Same category

More DEXes

DEXes rankings
Uniswap logo

Uniswap

DEXes

Score 7.1 out of 10

Uniswap is a long-running wallet-based exchange for crypto swaps, worth a look if you understand smart-contract and transaction risks.

Ethereum · Base · Arbitrum +2
Stellar DEX logoScore 6.8 out of 10

Stellar DEX is a built-in Stellar asset market with low network costs, but issuer controls and market liquidity deserve careful checks.

TVL $12.7M−4.8%Stellar
Pancakeswap logoScore 6.8 out of 10

PancakeSwap is a multichain DEX for swaps and DeFi products; it is worth a look if you understand wallet and smart-contract risks.

BNB Chain
Minswap DEX logoScore 6.5 out of 10

Minswap is an active Cardano DEX for swaps, liquidity and MIN staking; it is worth a look with careful checks on fees and pool risks.

TVL $12.0M−4.1%Cardano
Pancakeswap Token logoScore 6.5 out of 10

PancakeSwap is a multichain DEX for crypto swaps and DeFi products; it is worth a look if you understand wallet and smart-contract risks.

BNB Chain · Ethereum
SaucerSwap V2 logoScore 6.3 out of 10

SaucerSwap V2 is a Hedera DEX with wallet-based swaps and concentrated-liquidity pools; audits are a plus, but fees and licensing are unclear.

TVL $11.7M−12.6%Hedera

Same chain

More on Ethereum

Ethereum rankings
Lido logo

Lido

Staking Pool

Score 7.1 out of 10

Lido stakes ETH for liquid stETH; it is a substantial protocol, but returns and instant exit are not guaranteed.

TVL $17.9B−13.0%Ethereum · Solana · Terra +2
Aave V3 logo

Aave V3

Lending

Score 7.1 out of 10

Aave V3 is a multi-chain crypto lending protocol; its long track record and audits are reassuring, but borrowing and smart-contract risks remain.

TVL $14.0B−8.2%Ethereum · Base · Arbitrum +18
Ethereum Finance logoScore 7.1 out of 10

Ethereum is a public blockchain for ETH and smart-contract apps; it is worth exploring, but wallet and app risks remain.

Ethereum
Getblock logo

Getblock

Infrastructure

Score 7.0 out of 10

GetBlock sells blockchain nodes and data APIs for developers; its free tier is worth testing, but check usage costs and service terms.

Bitcoin · XRP Ledger · Ethereum +3
Score 7.0 out of 10

ENS maps readable names to Ethereum addresses; it is a long-running protocol, but wallet and smart-contract risks remain.

Ethereum
Bitvavo logo

Bitvavo

Centralized Exchanges

Score 6.9 out of 10

Bitvavo is a MiCA-authorized European crypto exchange with euro funding and low advertised trading fees, but custodial and product risks remain.

TVL $344M+10.2%Ethereum · Bitcoin · Solana +9

Guides

Guides about Balancer

All guides
  • DeFi

    Is Balancer Safe to Use in 2026?

    Balancer is a decentralized exchange and liquidity protocol built around configurable token pools. Its flexible design may suit experienced DeFi users, but a reported 2025 attack makes checking current contract and incident information essential before using it.

  • Security and scams

    What Happened in the Balancer Exploit of November 2025?

    Balancer suffered a major exploit on November 3, 2025, involving a precision-loss bug in Balancer v2 composable stable pools. Learn what happened, what is and is not known about its impact, and how to check your exposure safely.

Where the answers come from

Sources

No public sources were recorded for this page.

Last checked . Something wrong or out of date? Let us know and we will fix it.